Ring (Narrowed Tines)
Accessories for Installation of Saddle Matrices
High-Quality Stainless Steel Standard Ring to be used with Forceps.
Tines of the ring are narrowed.
Addition of an extra loop on the ring makes it more flexible and allows to operate in a wider range of opening without an increase of residual distance between tines after use.
WARNING!!!
When operating with ring:
1) make sure of the integrity of the ring and absence of rust on it;
2) avoid high-speed opening;
3) open the ring for not more than 10 - 12 mm width ;
4) open the ring for necessary width outside the mouth before placing it on a tooth.
CLEANING AND STERILISATION INSTRUCTIONS
Recommended to use Dry-heat sterilization process
1) Submerge instruments in cleaning agent solution with neutral pH for 20 min;
2) Rinse the instruments thoroughly with purified water for 3-5 min;
3) Perform standard moist heat/steam sterilization procedure following the sterilizer instructions
WARNING!!!
1) Do not use cleaning agents with a high percentage of chlorine and cleaners containing oxalic acid;
2) Do not keep instruments in liquid medium for more than 3 hours
Tines of ring № 1.033 |
Tines of ring № 1.099 |
Three rings listed on this page are compatible with saddle matrices
INSTALLATION WITH SPRINGCLIP № 1.003
Choose matrix of appropriate length and insert tines of springclip outside the patient mouth into the matrix side tubes | |
Install system onto the tooth. | |
Operating position on the mesial side. |